Replacing Water Level Pressure Sensor on Controller Board.

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Replacing Water Level Pressure Sensor on Controller Board.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 1, 2006 at 9:29 am #18843
    Number2
    Participant

    F&P
    LW085F
    Yellow Motor Controller. Series 8 426119E

    Any F&P engineers here that know which suppliers catalog the pressure sensors came from ie where can I source one from.

    -After it was overloaded machine wouldn’t spin just stepping checks.
    -Traced fault codes to faulty Water Level Pressure Sensor.
    -No impedance change across all 4 pins tested in place at different hose pressures. I assume it is bung.

    I want to desolder and replace the component rather than the whole controller. I’ve put a bit of work into this unit; conformal coating, breaking off the circuit board support tabs that give track corrosion issues, re-anodizing the heat sink etc.

    July 1, 2006 at 2:53 pm #180638
    Penguin45
    Participant

    Re: Replacing Water Level Pressure Sensor on Controller Boar

    F+P will only supply the sensor as part of the control board – p/no 426204AP.

    Check your email BTW 😀 .

    Penguin45.

    July 2, 2006 at 8:32 pm #180639
    Number2
    Participant

    Re: Replacing Water Level Pressure Sensor on Controller Boar

    Thanks Penguin. Any where in NZ that repairs modules?

    July 2, 2006 at 8:53 pm #180640
    Penguin45
    Participant

    Re: Replacing Water Level Pressure Sensor on Controller Boar

    I haven’t an NZ contact, No2, I’m sorry. Mind you Oz is only 1000 miles away…… 😀

    Perhaps a raid on the tip or a word with a local repairer for a scrap board?

    If you do find a company to repair it, please let me know as this has cropped up a couple of times.

    Thanks and good luck,
    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.