- This topic has 4 replies, 4 voices, and was last updated 19 years, 8 months ago by
.
-
Posts
-
has anyone come across a fault on these models where the machine will only work if you select the drain cycle. i have no drum action if i select any wash cycle and the pump doesn’t run either. i have checked the carbon brushes, heater circuit, the pressure switch clicks if i blow into it and valves check out ok, i then fitted a timer/module but still have only the drain cycle working, any help is welcome. thank you.
Re: whirlpool awm5145/3 only drains
Look at the door, has it moved over to the left slightly?
Used to take the hinge off, lay it curved side up and tap it with a hammer.
This was enough to centre the door again and it would then operate the interlock.Brian
Re: whirlpool awm5145/3 only drains
if its not the brushes,thre will be bad connection at the motor block ❗ had the same fault a while back,and it was the brushes
- You must be logged in to reply to this topic.