Whirlpool Cooker G2P90F

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Cooker G2P90F

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • July 25, 2006 at 4:22 pm #19432
    Kirk
    Participant

    I have job on with fault code FO3 what is it?

    Thanks Kirk

    July 25, 2006 at 4:25 pm #183066
    gegsy
    Participant

    Re: Whirlpool Cooker G2P90F

    The oven power unit is faulty and will need replacing.
    Put the 12 digit NC code up and will get you the part number.

    Greg

    July 25, 2006 at 4:39 pm #183067
    Kirk
    Participant

    Re: Whirlpool Cooker G2P90F

    Thanks for the quick reply I have 2 numbers!
    854184615011 or 140236030351

    Thanks Kirk

    July 25, 2006 at 4:42 pm #183068
    gegsy
    Participant

    Re: Whirlpool Cooker G2P90F

    P/no 481221458092 😉

    Greg

    PS – Its the 85….. that is the important one

    July 27, 2006 at 10:34 pm #183069
    realengineer
    Participant

    Re: Whirlpool Cooker G2P90F

    sorry but can i remind u that whirlpool boards will be coming WITHOUT software u need to configor our program board according to model
    dont waste money check b4 ordering
    a whirlpool engineer

    July 27, 2006 at 10:39 pm #183070
    gegsy
    Participant

    Re: Whirlpool Cooker G2P90F

    What no config sheet and snip of correct resistor ❓

    Greg

    July 28, 2006 at 6:38 am #183071
    johnmac11
    Participant

    Re: Whirlpool Cooker G2P90F

    Whirlpool do supply boards for ovens, dishwashers, washing machines and side by sides that have no software installed for engineers that have a SAM module.

    When ordering a board through SIOS look at the description, IIRC if it says “sam” or “basic” in the description then it is a blank board. There are always two boards listed on these models and the other is a normal programmed board.


    John

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.