Diplomat ADP8242 D/washer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #20211
    effzedarr
    Participant

    Not havin’ a good week so far so hope you can help!
    The above m/c fills,washes for about 2-3 mins then stops. No neons flashing up any fault codes or any bleeps either. Disconnect drian pump to test & check ,all ok, reconnect pump, switch back on & m/c then empties! It does this every time. It’s as though every time you reconnect the pump,the m/c resets itself, & empties. Carnt be the pump as it starts up at the start of the prog before filling. I think this Diplomat might be a Whirlpool clone!
    Hope someone can help, it’s doing my ‘ead in 👿

    #186215
    Dave_Conway
    Participant

    Re: Diplomat ADP8242 D/washer

    It’s a Smeg, dispenser coil I expect 😉

    Dave.

    #186216
    effzedarr
    Participant

    Re: Diplomat ADP8242 D/washer

    Cheers Dave I’ll give it a go,& let you know.
    regards Chris..

    #186217
    effzedarr
    Participant

    Re: Diplomat ADP8242 D/washer

    Sorry for the delay [customer on hols]. I checked the coil ,it was ok ,any other ideas. Dont think the customer will go to the expence of a PCB 👿
    Any help welcome. 🙂

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.