- This topic has 6 replies, 6 voices, and was last updated 19 years, 7 months ago by
.
-
Posts
-
Why does the board go bang on one of these ,i thought the door sw as per wm types but that looked ok when i opened it up .m
Re: Hotpoint WMA36P
Door Interlock is 95{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure to be the problem but do check :-
Wiring harness chaffing on cabinet, water leaks on motor, motor drawing too much current for starters 😉
P.s Trace the door interlock wires to the module board and if the tracks are blown in that area you will know for sure it was the Interlock that caused it 8)
Re: Hotpoint WMA36P
Had a couple of these t’other week. D,interlock replaced , board repaired by EMW. Good job done!!!! 😆 But do check dem’ wires. 😉
it was an insurance job so we changed motor ,door switch and board,we did check for chaffing but found nothing. the thing that worried me was when you do a wm machine and you split open the interlock and you can see a lovely splash mark inside the switch but this one was as clean as a whistle.
ps what does emw charge for a replcement board and are they formatted?mRe: Hotpoint WMA36P
Boards are £34.90+vat inc postage. Yes, they are set up for the model number so please quote the model when ordering. We also have a diagnostic sheet available with these boards – ask for one when ordering. Tony 0115 9652118
- You must be logged in to reply to this topic.