- This topic has 1 reply, 2 voices, and was last updated 19 years, 7 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
This dishwasher faulted full of water…..
Press on/off switch. Lights come on and you can select desired programme.
Nothing happens, apart from on one occasion it filled with a small amount of water and then stopped.
When I lift the red rod (which activates normally when base has flooded)
The pump will run.When I RESET the programme nothing happens other than the display goes back to zero. (No pump activation).
Am I right in thinking this is a board fault?
Thanks in advance.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.