- This topic has 3 replies, 3 voices, and was last updated 19 years, 7 months ago by
.
-
Posts
-
A few weeks ago, I was able to look over a Hotpoint Engineer’s shoulder at a ‘Company confidential’ Technical Bulletin about the current range of Indesit built dishwashers. Unfortunately he would not let me have a copy or a good read. …git!
The bulletin suggested cutting the soor seal short to reduce the back pressure in the tub :hmm:
Has anyone anyone seen this bulletin and able to divulge its content?
Bob
Re: Leaking Indesit dishwashers. Is there a technical bulle
I heard this one aswell, the only tip I had, was that the new bottom seal fitted inside the well of the m/c [after removing the old ‘un from the base of the door],then to protect the new seal you had to put some kind of tape over the sharpe edge on the base of the door. They quoted some part # that turns out to be obsolete :rolls: but all is not lost, get a hold of some of that aluminium foil tape that Hoover engineers used on the Starlite model vacs, it’s the same stuff! I’ve done a couple & so far so good, but typical Merloni design 😈 👿 .
Hope this helps ,cheers Chris.. 8)Re: Leaking Indesit dishwashers. Is there a technical bulle
The TB that I have ‘seen’ involves cutting the main door seal short at the bottom with scissors. It gives dimensions and shows a photo of someone cutting a short length from the bottom in both corners.
I can’t quite see what it is about? I get the feeling that it to stop a pressure build up in the tank???
I did see the company confidential notice at the top!
Bob
- You must be logged in to reply to this topic.