Bosch WFL245SGB/04 Does not spin

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Bosch WFL245SGB/04 Does not spin

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 9, 2006 at 10:39 am #20710
    terryj
    Participant

    Hi on the second wash of the day the washing came out wet(soaked) tried to use spin prog only for the pump to work and no spin.I have checked the belt and replaced the carbon brushes.Any ideas what to do next?

    September 9, 2006 at 11:26 am #188115
    Dave_Conway
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Is it draining all the water away ?

    Check the filter and waste hose connections etc for blockages 🙂

    Dave.

    September 9, 2006 at 12:24 pm #188116
    terryj
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Hi Dave just checked both hose and filter ,cleaned them, water is getting pumped out ok but still no movement on the drum.

    Terry

    September 9, 2006 at 12:32 pm #188117
    gegsy
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Hi Terry
    More than likely motor brushes. Unplug appliance and remove and check the length.
    Should be approx 1.5 inch in length when new FYI
    You will need to take motor off to gain access and please note make of motor as there are two motors on this appliance and will need this to obtain correct brushes.

    Greg

    September 9, 2006 at 1:16 pm #188118
    terryj
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Hi Greg I replaced brushes this morning very quick service from Shop@ but still no joy.
    Terry

    September 9, 2006 at 2:19 pm #188119
    gegsy
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Hi Terry
    If you are profficient in the use of a multimeter, you could check the motor pin resistances.

    Between:-
    Pin 2 and 3…. 0.8 ohms – 2 ohms
    Pin 4 and 5…. 4 ohms – 10 ohms
    Pin 6 and 7…. 14 ohms – 240 ohms

    :lesson: Please note these readings will be obtained with the appliance unplugged :plug:

    If that checks out the wiring from motor to module for continuity.
    If in any doubts, please feel free to use the engineer link below.

    Greg

    September 9, 2006 at 5:45 pm #188120
    terryj
    Participant

    Re: Bosch WFL245SGB/04 Does not spin

    Hi, motor checked out ok so did wiring, module inspected and found residue on pcb looks like over heated so module to blame,£100+ for new one so new machine @ £200 looks favourite thanks tho to Dave & Greg
    for advice.
    Terry

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.