SHOCKING MODULE

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › SHOCKING MODULE

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 26, 2006 at 8:10 am #21139
    fk
    Participant

    😉 Hi guys ! The Hotpoint service agent has just called on us to repair a WD640 in which the Three Phase power module needed replacing.
    Part No. C00099905 . There was a large warning thatstated that the large aluminium heat sink remains live after disconection and under NO CIRCUMSTANCES should the board be removed under 5 minuites after the power is disconected. Just thought there might be a few of you that would find out the hard way.

    September 26, 2006 at 10:25 am #189664
    iadom
    Moderator

    Re: SHOCKING MODULE

    A well documented warning that has been aired on the boards many times, a repeat of this can do no harm at all though. 8)

    Jim.

    September 26, 2006 at 9:41 pm #189665
    machineman
    Participant

    Do these mods have to be formatted or do you just bung them in.m

    September 26, 2006 at 9:58 pm #189666
    iadom
    Moderator

    Re: SHOCKING MODULE

    They have the eeproms, just like all the other Indesit electronically controlled machines, they will need to have the correct eeprom fitted, the original replaced or a blank eeprom, reprogrammed with the EMIT enabled laptops I would guess. 😥

    Jim.

    September 27, 2006 at 3:41 pm #189667
    Seamy
    Participant

    Re: SHOCKING MODULE

    The new Mieles’ mostly have 3 Phase motors in them also so the same applies there. :lesson:

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.