whirlpool wdp 2440 problem

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › whirlpool wdp 2440 problem

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 12, 2006 at 10:10 pm #21654
    meza
    Participant

    I have whirlpool WDP 2440 with a problem. After a short time the program selected jumps to pre wash and the start button flashes 4 time.
    Any ideas would be much appreciated.

    October 12, 2006 at 10:15 pm #192048
    gegsy
    Participant

    Re: whirlpool wdp 2440 problem

    Hi Meza
    You might want to re-check that model number, better still if you can find the 12 digit number below the barcode sticker, that would be great.

    Greg

    October 12, 2006 at 10:22 pm #192049
    meza
    Participant

    Re: whirlpool wdp 2440 problem

    Hi Greg,

    sorry number is ADP 2440 WH, and service number is 8542 444 15510.

    October 12, 2006 at 10:42 pm #192050
    gegsy
    Participant

    Re: whirlpool wdp 2440 problem

    Hi
    Make sure it is emptying ok, if that is ok I would be looking for a crud build up below the filters, around the water indicater (WI) this is situated at the 3 o clock position.
    If all clear there, you would be looking at a poor connection to WI,faulty WI or faulty PCB.

    HTH

    Greg

    October 21, 2006 at 10:36 am #192051
    kandl-appliancerepair
    Participant

    Re: whirlpool wdp 2440 problem

    4 flashes on a Whirlpool is a drainage problem, is it brand new? check the installation, maybe a bung in the sink trap, or drainhose pushed into the standpipe to far?


    has there been a broken glass in there?, take the filters out and feel inside the sump to see if anyting is there. If not, power off, remove the plinths make sure you have towells handy, because you will get wet! the pump is just a twist lock, push the clip down and twist the pump anti clockwise and you have access the the impellor.

    (presuming the model is a full size dishwasher)

    October 21, 2006 at 2:15 pm #192052
    gegsy
    Participant

    Re: whirlpool wdp 2440 problem

    kandl-appliancerepair wrote:has there been a broken glass in there?, take the filters out and feel inside the sump to see if anyting is there.

    Take care incase there is glass in there that you don’t cut yourself 😉

    Unplug appliance if you are going to investigate further :plug:

    Greg

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.