access to siemens draining pump

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › access to siemens draining pump

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 24, 2006 at 9:53 pm #21985
    jrrc
    Participant

    hi ,have a seimens slimline sf24200g8 which has led a blameless life for 6 years but now will not drain .Have located a spare pump but cannot see how to access the old one .The base of machine is plastic with no obvious means of access and have tried entry through the floor of the chamber,unscrewed everything but cannot get to it.If anybody has the knowledge and/or experience I would be most grateful .

    October 24, 2006 at 11:43 pm #193295
    Penguin45
    Participant

    Re: access to siemens draining pump

    Unplug.
    Remove door outer panel.
    Remove kick panel.
    Remove lower inner metal panel.
    Remove transfer pipe in the left hand corner.
    You should just about have room to twist and release the pump. If the locking latch won’t release, you may have to remove the left hand side panel – which means the lid has to go as well :rolls: .

    Should point out that I have fitted 1 (one) drain pump motor in the last 5 years on these and their full sized bretheren. You are absolutley sure that there are no blockages – pump, hoses, sink coupling, fill/drain matrix?

    Regards,
    Penguin45.

    October 25, 2006 at 10:15 am #193296
    jrrc
    Participant

    Re: access to siemens draining pump

    thankyou very much your advice was very helpful

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.