Whirlpool DW ADG 722

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool DW ADG 722

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • October 31, 2006 at 11:13 pm #22171
    kevinlewis
    Participant

    Semi intergrated with a programme selector and a start button with a light above it that flashes. Thats all it does.Nothing has power except this start light.There was water in the tub but the waste pump was not getting any power.
    Checked the door switch and inspected the selector pcb and main pcb and door harness. Everything looks ok. Did not have the time today to remove from its housing.
    Any ideas?

    November 1, 2006 at 12:55 am #193883
    Penguin45
    Participant

    Re: Whirlpool DW ADG 722

    PCB – 99.99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure. Steady flashing light can be NTC sensor, but programme should abort with drain pump running.
    Chris.

    November 1, 2006 at 4:39 pm #193884
    kevinlewis
    Participant

    I suppose you mean the PCB at the bottom. I could get the part number from ASD. anyone know if there is a refurbished pcb available?

    November 1, 2006 at 9:28 pm #193885
    gegsy
    Participant

    kevinlewis wrote:I could get the part number from ASD

    Part number is 481221478166.

    Greg

    November 1, 2006 at 9:58 pm #193886
    Penguin45
    Participant

    kevinlewis wrote:is a refurbished pcb available?

    QER.
    Chris.

    November 1, 2006 at 10:58 pm #193887
    clivejameson
    Participant

    Re: Whirlpool DW ADG 722

    IIRC if the pump is blocked/faulty it will stop with a flashing start light?

    Have you tried resetting (hold down start for 5 seconds)? The drain pump only should run for 1 minute and then stop, after which it can be re-programmed.

    November 2, 2006 at 9:07 am #193888
    kevinlewis
    Participant

    Re: Whirlpool DW ADG 722

    Is this information available and where from?
    Ref to 11RC—-is this a fauly code? there is no display on this model only one neon light above the start button.

    November 2, 2006 at 9:12 am #193889
    gegsy
    Participant

    Re: Whirlpool DW ADG 722

    Hi

    IIRC = If I Remember Correctlty 8)

    Greg

    November 4, 2006 at 9:52 am #193890
    kevinlewis
    Participant

    Re: Whirlpool DW ADG 722

    returned and reset. found pump blocked. Now working ok.
    Thanks for the advice.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.