- This topic has 2 replies, 2 voices, and was last updated 19 years, 5 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Getting e16 code which indicates overfill but the level looks fine.Pressure vessel and hose were clear .The switch clicked on and off ok[single level] is it likely to be the p/switch or a board fault.
Re: Hotpoint wdm73 E16
i’ve had an earth fault on the heater show up strange faults on these models before, so might be worth checking. have you tried setting program and blowing into the p/switch to see if it sets?
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.