- This topic has 5 replies, 2 voices, and was last updated 19 years, 5 months ago by
.
-
Posts
-
Hi guy’s,heres’s a good one,with the machine turned on and door shut,and in the finished position the start button flashes twice ,then off then flashes twice etc,when prog selected the 1200 spin light comes on and m/c sequences as follows,main wash,rinses,drain ,check inlet,check drain,excessive powder,then nothing,then it repeats sequence untill turned off,i have checked all meterable components and all seem to be ok,not able to check part at rear of soap drawer any ideas!!
Re: miele premier 500 w828
Sorry my laptop is in for repair at the minute & i’ve all my technical info on there.
Sounds as if the control knob could be either broken or out of position.
I don’t know if this machine has a demonsration mode on it?
Some of the newer ones go through that sequence of flashing through all the options but only if set in demo mode as in a showroom.
You might wanna give Miele Tech guys a bell, they’re quite well informed & helpful.Re: miele premier 500 w828
thanks seamy i will give them a try,my laptop’s gone west too,I now use it as a discus 😀
Re: miele premier 500 w828
Just chatted to another Miele engineer & he says it sounds like a ribbon cable fault, check the ribbons on control board. Edge connections on board may need dab of solder with iron, thats his advice.
- You must be logged in to reply to this topic.