Whirlpool AWZ410 washer/dryer: thermistor wiring?

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Whirlpool AWZ410 washer/dryer: thermistor wiring?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 14, 2006 at 9:33 pm #22562
    seanw
    Participant

    My washer/dryer recently shed its belt but rather annoyingly pulled the wires out of the thermistor/thermostat in the process.
    I can’t quite work out where to reconnect?

    There are three wires:
    1 grey (thicker than other 2) coming from heating elelent.
    2 visually identical white wires labelled “TH” coming from the loom.

    See photo attached in user gallery.

    I’ve established that the connector top right in photo is not/has not been used.
    Continuity test shows a circuit between top left and top right terminal.
    Same test shows a circuit between bottom left and bottom right terminal.
    No circuit between top and bottom terminals.

    2 white wires are in same circuit

    Any idea of the correct connection for these 3 wires??

    cheers
    sean

    November 14, 2006 at 10:26 pm #195479
    Penguin45
    Participant

    Re: Whirlpool AWZ410 washer/dryer: thermistor wiring?

    The thermostat should show a reading of just about zero ohms.
    The ther    mistor should show a reading in kOhms.
    Heavy wire goes to the thermostat, lightweight wires go to thermistor.

    Mind the power,
    Regards,
    Penguin45.

    November 16, 2006 at 9:52 am #195480
    seanw
    Participant

    Re: Whirlpool AWZ410 washer/dryer: thermistor wiring?

    Top is thermostat, bottom thermistor.
    Machine working fine.

    Thanks very much

    Sean

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.