Miele W828 error code

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Miele W828 error code

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 27, 2006 at 1:55 am #22889
    Blinky
    Participant

    Am not happy at the moment. Great pressure is being applied from the better half to get her washing machine going again. We have tried reseting as per manual but no joy 😥 The machine commences its cycle by filling with water but thats as far as it goes. No drum movement then the rinse light flashes about thirty times a pause and then another round of flashing. the water is emptied out and that is it….
    Any help would be appreciated 🙂

    November 27, 2006 at 2:38 am #196464
    bigsmokepiker
    Moderator

    Re: Miele W828 error code

    More than likely worn motor brushes
    Or it could be motor connections wiring harness fault

    But i would look at motor brushes First

    November 27, 2006 at 12:24 pm #196465
    Blinky
    Participant

    Re: Miele W828 error code

    Thanks for your input. I will check it out. I also called a local repair man to whom I gave the symptoms and his reply was that their was an electronic board gone caused by the dampers being worn out on the bowl support. Thus the suggested repair price (parts only) was approximately $100 AUD for the dampers and $350 for the board 😯 So I hope that you are right. Thanks again.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.