Bosch tumble…WTA3204GB/09

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch tumble…WTA3204GB/09

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 29, 2006 at 4:34 pm #22958
    robbra
    Participant

    Hi lads,
    This dryer heats for 10 secs on start then heat goes off on every anti-clockwise tumble and comes on for a few seconds clockwise but very rare. Tried with damp washing, still the same.
    Anything to test and is this a common fault? Customer said it has dried badly since new. Measue 172 ohms between carbons on sensor circuit.
    Any ideas?
    Thanks
    Rob

    November 29, 2006 at 5:16 pm #196637
    Martin
    Participant

    Re: Bosch tumble…WTA3204GB/09

    Well the power to the element does go off on the shorter off the 2 directions (whichever that is – I forget?) But as the power to the element only comes on infrequently during the main tumble direction, I can only assume the module (264490) is at fault? (dodgy relay on the board?)

    But as the Module is over £120 please don’t take my advice too literally 😥

    November 30, 2006 at 4:12 pm #196638
    robbra
    Participant

    Re: Bosch tumble…WTA3204GB/09

    Thanks Martin,
    No other replies and I think you are probably right so will advise customer. Here goes :rolls:
    Rob

    February 9, 2007 at 1:03 am #196639
    scots
    Participant

    Re: Bosch tumble…WTA3204GB/09

    Hi Rob

    Just read thru your fault, this is identical to what I have. I tested everything and came to conclusion it has to be PCB….WRONG 😳 I tried new one and still the same fault. I suspect it can only be thermister… but which one, there are 2. One on exhaust and another to protect heater?

    Can you let me know how you got on

    Thanks
    Brian

    February 9, 2007 at 10:36 am #196640
    robbra
    Participant

    Re: Bosch tumble…WTA3204GB/09

    Hi Brian,
    Quoted a pcb and she said no so I got her a White Knight which she says is far, far better and the Bosch is in the garage waiting for the summer for me to play with so, I’m sorry I can’t help.
    Surely there are some BSH men who have come across this and can throw some light on it?????
    Rob

    February 9, 2007 at 1:58 pm #196641
    scots
    Participant

    Re: Bosch tumble…WTA3204GB/09

    I will not give up…

    Will let you know when I repair it.

    Brian

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.