Beko Fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko Fault

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 10, 2006 at 11:26 am #23259
    happycack
    Participant

    Got a problem with a nearly new Beko WMA 1510W. Put it on any hot program (2 or 3) and whilst filling the timer advances to 4 then once filled goes to 5 only permitting a cool wash. It does heat on this section and the element is O.K. No apparant way of resetting the timer like Indesits etc.
    Any ideas?

    Regards.

    December 10, 2006 at 1:04 pm #197533
    bobokines
    Participant

    Re: Beko Fault

    This machine does advance quickly through to that position before it heats and then heats to the temperature of the preselected program. Have you checked the temperature or are you just assuming that it’s only heating to 40C?

    Bob

    December 10, 2006 at 1:05 pm #197534
    Flyman
    Participant

    Re: Beko Fault

    Think this is perfectly normal. Select the programme then the timer dial will advance to show where in the wash cycle it is but the original setting will be remembered and it will do that particular wash. So if you select a 60 wash the dial will advance but it will still do the 60 wash. Lots of calls for this from people who have had the machine for months and swear blind it has not done it from day one. 😕

    December 10, 2006 at 4:58 pm #197535
    happycack
    Participant

    Re: Beko Fault

    Thanks chaps, I’ll check with customer.

    December 10, 2006 at 7:21 pm #197536
    Washman
    Participant

    Re: Beko Fault

    Hi

    If you look in the user manual about page nine I think it will tell you about timer advancing. The timer is acting as a program selector switch for module which controls most of the functions.

    Mike

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.