Belling DW problems

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Belling DW problems

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 15, 2006 at 5:16 pm #23398
    S1MON
    Participant

    I have a Belling dishwasher that is intermitantly stopping during a cycle. There is no pattern to this, it does it on different washes but also runs right through! They said its happened around 10 times in the past 3 months and the rest of this period of time it has worked fine.

    When it stops the display flashes, i havent seen this as it worked fine while I was testing it. It leaves water in the base when it stops and doesnt appear to have done the final rinse?

    Ive gave the m/c a once over its only 13 months old, all componets have mega fine etc so any ideas

    IDW603
    20052006744

    December 18, 2006 at 4:37 pm #197993
    Mark_Fixcookers
    Participant

    Re: Belling DW problems

    Most likely problem with the 603 is a pressure switch problem
    If it isnt flashing up an “E” number in the display, then second most likely cause is the door catch is opening slightly, normally caused by poor installation allowing the cabinet to flex too much

    If there is any water in the pressure switch hose, replace it. There is an unnoficial mod kit, aint no part number sorry, which basically lengthens the pressure switch hose so that you can loop it a little higher.

    What “E” number is it flagging up??

    December 18, 2006 at 8:24 pm #197994
    S1MON
    Participant

    Re: Belling DW problems

    Its not flashing a E number!

    Ill check the pressure system

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.