old zan d/w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › old zan d/w

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 22, 2006 at 8:46 am #23569
    streetlighter
    Participant

    Hi all
    I have an old zan d/w the one with the 2 blue syphone tubes under the round cap, which will do the first fill but the p/switch wont reset when the water pumps out. (so heats empty 😯 )
    when I pull the p/pipe of the sump the p/switch clicks and some water comes out then i have fill again.
    Do you think I have a lazy p/switch or a problem with the sypone set up, I have cleaned it 6 times so far ? should there be any water on the pipe side if the syphone tube?

    Ta

    Paul

    December 22, 2006 at 9:18 am #198615
    clivejameson
    Participant

    Re: old zan d/w

    Hi Paul

    If the syphons were blocked then the port underneath the draining end of the syphons is prolly blocked too…if you look underneath you’ll see a small looped hose that appears to come out of the sump and double back into it, that’s where the problem will be 😉

    December 22, 2006 at 9:55 am #198616
    streetlighter
    Participant

    Re: old zan d/w

    Thanks for the quick reply clive on wayback there now to have another go.
    I will try that.

    Ta

    Paul

    December 23, 2006 at 6:04 pm #198617
    streetlighter
    Participant

    Re: old zan d/w

    Thanks clive it was the loop of the sump

    Ta. again

    Paul

    December 23, 2006 at 9:54 pm #198618
    clivejameson
    Participant

    Re: old zan d/w

    No probs Paul, always happy to help…have a happy Christmas 😀

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.