TDC60S dryness module

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › TDC60S dryness module

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 2, 2007 at 12:45 pm #23743
    Simon46
    Participant

    Fitted a new one for no heat fault. Pressed on schrack relay during operation confirmed intermittent operation (buzzing and clicking and light coming on/off).

    Replaced module now cust says dryer runs too hot and doesnt finish cycle.
    Anybody had faulty out of box new module? (1702136)

    Regards
    S

    January 2, 2007 at 4:04 pm #199197
    Martin
    Participant

    Re: TDC60S dryness module

    The fault sounds a little different this time though? 😕

    Probably now rather than a fault Module, the connection between module and contact brush is at fault?

    January 2, 2007 at 6:07 pm #199198
    Simon46
    Participant

    Re: TDC60S dryness module

    Thanks Martin. Also the programmed dry setting doesnt finish and the timed has no tumble cool. 😕 has anybody got a wiring diagram for this in the unlikely event a connector may have been put on incorrectly?

    Thanks
    Simon

    January 2, 2007 at 7:24 pm #199199
    iadom
    Moderator

    Re: TDC60S dryness module

    Simon46 wrote: has anybody got a wiring diagram for this

    😉

    January 2, 2007 at 9:36 pm #199200
    Simon46
    Participant

    Re: TDC60S dryness module

    :worthy:
    S.

    January 10, 2007 at 9:35 pm #199201
    Simon46
    Participant

    Re: TDC60S dryness module

    Replaced module again but also found Earth high resistance (varying)from black wire (module)to cabinet. Stacked on WMA (vibration?).
    Found machine screw loose that earths black wire to module 😮 . Stripped thread on cabinet(painted).
    Made new earth and scratched paint away. Fingers crossed.

    S.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.