Whirlpool Dishwasher G2P DWI/1 WH

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Dishwasher G2P DWI/1 WH

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 6, 2007 at 4:11 pm #23899
    grooster
    Participant

    Hi,

    Just been out to a whirlpool dishwasher G2P DWI/1 WH and its continously beeping. I can reset the timer and restart and as soon as the door closes it starts to beep again. I’ve tried the test programme but it wont go past the door closure part like i say. The start button flashes once intermittantly. This says its the NTC but i’m not too sure. Last time i had anything like this the NTC fault only occured after the programme tried to heat for a few minutes not this soon.
    I personally think its the user board but has anybody got any ideas before i order one.

    Thanks for your time

    Nick

    January 6, 2007 at 4:35 pm #199781
    maltheviking
    Participant

    Re: Whirlpool Dishwasher G2P DWI/1 WH

    Hi Nick

    Go for the NTC, it’s cheaper than the board and it is a common problem with Whirlpool. The worst than can happen is that you gain one for stock 😉

    Pt no 481228268035 check it though I may be wrong 😳
    Mal

    January 6, 2007 at 7:38 pm #199782
    DentedPorsche
    Participant

    Re: Whirlpool Dishwasher G2P DWI/1 WH

    If it’s way out of spec then the fault will be detected before it starts washing.
    With a lot of ntc faults you can’t run the diagnostics until it’s been changed.

    Brian

    January 8, 2007 at 8:37 am #199783
    grooster
    Participant

    Re: Whirlpool Dishwasher G2P DWI/1 WH

    Cheers for the help guys. I’ve just ordered the NTC.

    Thanks

    Nick

    January 8, 2007 at 9:11 am #199784
    maltheviking
    Participant

    Re: Whirlpool Dishwasher G2P DWI/1 WH

    Hi nick

    Let us know how you come on

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.