zanussi dishwasher zsf 6126

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi dishwasher zsf 6126

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 7, 2007 at 6:31 pm #23925
    SparkyP
    Participant

    Pnc no:911919018
    Anyone had this fault?
    Machine starts to drain but will not fill. Valve circ pump pressostats heater etc all ok. Even had the front off for broken wires.
    Don’t know if there is a test program.
    No flashing lights to show an error.

    Sparkyp

    January 7, 2007 at 7:28 pm #199871
    iadom
    Moderator

    Re: zanussi dishwasher zsf 6126

    The fill control systems are the first point of call on these machines.
    good article here. http://tinyurl.com/ymgwb2

    Jim.

    March 28, 2007 at 2:56 pm #199872
    grooster
    Participant

    Re: zanussi dishwasher zsf 6126

    Hi,

    I’ve just been out to the exact same machine as this one, with the same symtoms. It starts emptying and then goes dead, lights stay on as though working fine, no flashing lights. First port of call was the water valve but its reading fine. Checked everything else possible. It isnt the usuall type of zanussi with the decalcifier unit which gets guncked up, its the newer version.

    Everything tells me its the pcb. No visable signs of damage though. All i seem to do on zanussi machine these days are pcb’s.

    If sparkyp fixed the job and is still around on this site any chance you can tell me how you got on.

    Any help would be appreciated.

    Cheers

    Nick

    March 28, 2007 at 8:38 pm #199873
    comptonappliances
    Participant

    Re: zanussi dishwasher zsf 6126

    try checking the valve on the inner side of the iwms tank had a few faulty of late have also found faulty pressure switch b4 on a brand new appliance

    March 28, 2007 at 9:26 pm #199874
    dpm
    Participant

    any diagnostics?

    April 14, 2007 at 7:20 am #199875
    grooster
    Participant

    Re: zanussi dishwasher zsf 6126

    Just to fill you all in on this fault. I ordered a pcb for it at a hunch after checking valve and pressure switch and its worked a treat.
    I seem to be getting more and more electrical problems (PCB) with Zanussi nowadays. Personally i think the quality has come downhill rapidily over the last 5/6 years. I used to recomend Zanussi if a customer asked me my advice, but not a chance now.

    Thanks for your ongoing help guys.
    Nick

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.