Error with MW051-U

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Error with MW051-U

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 12, 2007 at 2:04 am #24064
    chrisduryea1979
    Participant

    Hi hope someone can help.

    I live in Brisbane Aus. I have a F&P MW051-U
    I have checked the forum and did the diagnostics and came up with the following code.

    0 0 1 0 1 0 1 1
    Long Short Rinse Final Spin
    Wash Wash Rinse

    I appears as though the drive trying to turn the drum but only turns all little each time.

    Thanks in advance
    Chris Duryea
    Brisbane, Qld Australia

    January 12, 2007 at 7:41 pm #200517
    Penguin45
    Participant

    Re: Error with MW051-U

    The good old Out of Balance problem…….

    1) Check bias spring is attatched to tub.
    2) Check suspension is correctly attatched and free to move.
    3) Check function of switch – it should be free to move easily and not be stiff, corroded or wet. Wiring can also deteriorate.

    You’ll need to take the top deck off to check fully – two screws at the back.

    Regards,
    Penguin45.

    March 25, 2007 at 10:43 pm #200518
    somotec
    Participant

    Penguin45 wrote:The good old Out of Balance problem…….

    1) Check bias spring is attatched to tub.
    2) Check suspension is correctly attatched and free to move.
    3) Check function of switch – it should be free to move easily and not be stiff, corroded or wet. Wiring can also deteriorate.

    You’ll need to take the top deck off to check fully – two screws at the back.

    Regards,
    Penguin45.

    I’ve had the same but it goes away – looks like I’ll have to do some maint.
    I’ve see reference to different “phases” of F&P washers how do I know what mine is ?
    Can I get a list of all the codes for this machine.
    thanks john

    March 25, 2007 at 11:51 pm #200519
    Penguin45
    Participant

    Re: Error with MW051-U

    If yours is an 051, it’s a phase 2.

    No, I can’t publish the codes. F+P don’t mind if we answer your specific questions, but will get somewhat peeved if I put up all their copyright tech info. Sorry.

    Check your OOB switch for corrosion and dodgy wiring – it’s a regular thing.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.