wma 10 conditionor not going through clogging and wma 33

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › wma 10 conditionor not going through clogging and wma 33

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 17, 2007 at 8:07 pm #24231
    andysam
    Participant

    any one know why conditioner dosnt go in wma 10 and cloggs
    also have a wma 33 that trips main when motor is plugged in checked wire loom and one wire insulation is no good. as soon as motor is in bang changed motor still same door interlock ok pump ok heater ok anyone know????

    January 18, 2007 at 6:18 pm #201214
    admin
    Keymaster

    For second problem: at wma33 if you have rotor to earth schorted (if it is the model with motor on top you can only cut the earth wire from motor connector). Not before checking brush case for earth-leakage.

    For first one check all inlet valves or use conditioner diluated.

    January 18, 2007 at 6:30 pm #201215
    effzedarr
    Participant

    Re: wma 10 conditionor not going through clogging and wma 33

    WMA models are well known for dispencer drawers blocking up, just fit a new ‘un! Or a cheap way is to remove the dispencer & soak overnight in a bleech/water solution ,then rinse in hot water. You could also try a pressure washer on it ,but that is on the extreme side!!
    Chris..

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.