- This topic has 1 reply, 2 voices, and was last updated 19 years, 2 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi Guys
Symptons are leaking in base blowing suppresor .
To date I have changed
support arm kit for top hose
motors for lids -top and bottom (New Style)
Cleaned the top surround of each tub .
every time I run it up after repair it works okay ,customer does 3 or 4 loads and hey presto water in base and blown suppressor !
Any ideas ?
LawrenceRe: F+P DD6L31H
Hi Lawrence,
Check the drain hose on the drawer that you changed the support arm on, once arm goes it is not uncommon to get a pin hole due to the hose rubbing.
Apart from that all you have is either the heater/motor seals or salt chamber seal.
If I come across one like this I usualy run both drawers with the door off and can spot the leak easily.
John
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.