Hinari MX904CEGSS fuse blown

Home › Forums › Public Support Forums › Spare Parts Help › Hinari MX904CEGSS fuse blown

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 17, 2007 at 10:40 pm #25141
    tony_orr
    Participant

    My MX904 has blown the 5KV 0.75A fuse cartridge and most likely the magnetron has died as the heater reads 0 Ohms. I’ve done a search, no one seems to advertise this rating of fuse. Can you help ? The magnetron is a Panasonic 2M210-M1, although this is obtainable I’d prefer to get both from the same supplier.

    February 17, 2007 at 11:11 pm #204654
    Dave_Conway
    Participant

    Re: Hinari MX904CEGSS fuse blown

    Hi Tony,

    A quick question please, are you in the trade ?

    As far as I am aware only the most unscrupulous spares supplier would sell a magnetron and the safety fuse to anyone without the correct test and safety equipment to be able to fit these parts.

    Dave.

    February 18, 2007 at 5:11 pm #204655
    tony_orr
    Participant

    Re: Hinari MX904CEGSS fuse blown

    Thanks for the question Dave, I’m an electronics engineer and work as a service engineer on high power (up to 250KW) amplifier units etc. , so I have a good range of experience and test equipment, but not a microwave leakage tester. If you think I don’t have the experience needed I’ll buy the bits and get someone in the trade to fit them.
    Regards, Tony Orr.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.