- This topic has 4 replies, 3 voices, and was last updated 19 years, 1 month ago by
.
-
Posts
-
Help,
Sent pcb for repair/check and repairer found that led 2 was stuck on, cant see any lights on when card reinstalled yet continue to have fault,unless its one of the leds you cant see ?
Anybody know the cure for led 2 and or what the two leds you cant see are for,think a new dishwasher only cure ?cheers, diy
Re: smeg dwi 710e1
What actually is the problem with the dishwasher? i.e. what does is do or not do?
Re: smeg dwi 710e1
the programme times are too long does not seem to be switching the heater on for long enough,after about 5 mins into programme makes click sound 2 bleeps and continues then repeats this every2 mins approx,no visible fault led indications. pcb repairer said I may need to send card back for reset as I should have cured fault before refitting.
Repairer said engineer would know fault for led 2 stuck on? Heater only on for couple of seconds every 2 mins.Cheers,
diy
Re: smeg dwi 710e1
If LED2 is flashing and LED5 is steady, you have the E2 error and should read this:
http://www.ukwhitegoods.co.uk/modules.p … ge&pid=102If LED2 is just lit, I would suspect some sort of computer problem and you should ask your repairer to try again.
You could try the reset procedure; it might make a difference. Type “SMEG AND reset” into Search for this forum only to find – plenty of references.
Regards,
Penguin45.
- You must be logged in to reply to this topic.