HOOVER HNWL 6136

Re: HOOVER HNWL 6136

urrghh

hoverhave a hand held terminal to configure those…

and they dont supply them to trade

but theyll programme urs for £95 😈

typical

Re: HOOVER HNWL 6136

helo_75 wrote:and they dont supply them to trade

Indeed they don’t, and in fact they come as a Programming Unit Kit (Pt No 4900727) Which comprises of an Interface Box, Mains Cable, Serial Cable, Ribbon Cable, Shunts and an extracting tool. Software (downloaded from the Internet) for each model’s coreboard can be loaded (Winzipped files) and programmed. All products (w/m’s, D/w’s, Ovens etc) can be configured, re-programmed and fault diagnosed using this equipment. 😯

The same sort of apparatus is now being used by most whitegoods manufacturers (currently Hoover, Indesit, Miele supply to their staff only) that do not pre-programme their module/interface boards and eeproms. Which is a worrying prospect for all independents, work providers and insurance companies whenever this type of component failure occurs.

Technology gone stark raving mad if I am any judge? 👿

Re: HOOVER HNWL 6136

Penguin45 wrote:09200452 – core board, preprogrammed.

Is what you need………
Chris.

Re: HOOVER HNWL 6136

Martin & Chris,
I wonder why in this forum nobody talks about the way to bypass this kind of “unrespect” 👿 from manufactures for our job.
I’m talking about anybody (who had a little knowledge about computers and electronics in order to do some job to reprogram one EPROM) can discuss and interchange files (bin’s). It isn’t so hard to dismantle one chip and run one computer program. I’ve spoke from my position, with one little and easy to made programmer which can be find free on internet (or more easily to buy). So I managed with Whirlpool/Bauknecht; Ariston/Indesit; Hotpoint. I have also some files from Hoover/Candy like here related. But in this case I didn’t do this kind of job on Hoover in order to see its results because I did not need.

What I wanted to say is that it’s more cheep and quickly, in order to complete one job to buy one (EEPROM) programmer and using all people to share files found on the jobs instead to buy another pre-programmed programmer or module from suppliers.

Can also buy such tools: from Whirlpool so called SAM; from Indesit/Ariston so called Hardware Key Seriall together LB Sat and WM Doctor and so on. But like Martin said is like just for them own trade.

Re: HOOVER HNWL 6136

You weren’t seriously going to buy it from espares, were you?

My tech info came up with the number – Martin might like to double check in the morning – he has access to a bit more than I do.

Chris.