hotpoint wf240p

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wf240p

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 15, 2007 at 9:36 pm #25877
    robbo1973
    Participant

    hi been here today press start the door locked light comes on, door locks fills for a few seconds then door locked light goes out and thats it no fault codes any one had this before thanx.

    March 16, 2007 at 11:16 am #207937
    PGS
    Participant

    Re: hotpoint wf240p

    maybe just door lock overheating and going open circuit, worth a try.

    March 16, 2007 at 10:39 pm #207938
    aqualectric
    Participant

    Re: hotpoint wf240p

    Most likely its the edge connector to the facia PCB not making a good contact, or the connections are oxidised. Pull off the edge connector plug, pinch it with pliers gently to tighten it, clean the edge connections with some emery paper and refit the plug. I had this a few weeks ago and this method sorted it. 8)

    Hope that helps,

    Steve.

    March 20, 2007 at 4:34 pm #207939
    robbo1973
    Participant

    Re: hotpoint wf240p

    thanx for help lads problem was a broken wire in motor harness.machine would lock light on then off and a quick spurt of water and thats it something to look out for.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.