Fisher & Paykel GW701 Fills & Drains

This topic has 5 replies, 3 voices, and was last updated 19 years ago by verylost.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
March 26, 2007 at 4:35 am #26130

verylost
Participant

hi there, washering machine starts fills to level starts washing then starts to fill with more water and drains at the sametime. Checked fault codes found 132 could you help please.

March 26, 2007 at 8:20 am #208911

Penguin45
Participant

Re: Fisher & Paykel GW701 Fills & Drains

Short circuit in motor or wiring harness can cause this, as can the rotor position sensor being out of position, causing false readings. Fill and empty (you didn’t say if the pump was running or not) together can also be a syphoning problem – end of drain hose too low in outlet pipe.

Penguin45.

March 26, 2007 at 8:24 am #208912

verylost
Participant

Re: Fisher & Paykel GW701 Fills & Drains

hi there no the pump is not running i am just about to remove front cover to check wiring harness ?? also washer been in same spot for more than 5 years, but outlet could be to low ??

March 26, 2007 at 9:11 am #208913

silvercody
Participant

Re: Fisher & Paykel GW701 Fills & Drains

hi,try blowning hard down the pressure tube on the side of the bowl .turn off power dissconnect from top.

March 26, 2007 at 9:57 pm #208914

verylost
Participant

Re: Fisher & Paykel GW701 Fills & Drains

hi there, problem fixed found rotor position sensor being out of position and wiring loom damaged, repaired and retested ok. Can you help on how to reset fault codes ?? thanks for the help 😀

March 26, 2007 at 11:24 pm #208915

Penguin45
Participant

Re: Fisher & Paykel GW701 Fills & Drains

verylost wrote:Can you help on how to reset fault codes ??

You shouldn’t have to…….. Last fault is retained in the memory for 8 (I think) washes – if no recurrence, it should delete by itself.

Penguin45.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.