- This topic has 3 replies, 2 voices, and was last updated 19 years ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
hi servis m9010w 20034708258 014077059 machine washes fine but then jumps to end missing rinse and spin. original board was sent to emw for burning on spades as normal but same fault.has been returned to emw but fault still there any ideas checked everything.
Re: servism9010w
Original board burnt.
Recon Board skipping programmes.As you have checked everything i would say recon board faulty, or wiring incorrect, or poor connections. (did you change loom or individually spade wires?)
Have you run it on its test programme???
Re: servism9010w
sent recon board back once,crimped edge connectors tight changed individual spade connestors. what is the test programme how do you access this.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.