hotpoint BMW929

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint BMW929

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • March 31, 2007 at 7:41 pm #26283
    machineman
    Participant

    Dead as a dodo .mains coming in other than that dead .are the boards on these prone to failure or am i missing something.m

    March 31, 2007 at 10:48 pm #209535
    iadom
    Moderator

    Re: hotpoint BMW929

    That model number is not recognised on Partfinder?

    Could it be a BWM129. 😉 I think BMW is a car or a motorbike. 😀

    PCB’s can give this fault but worn motor brushes/duff motor will also cause this.

    Jim.

    March 31, 2007 at 11:00 pm #209536
    hotpnt
    Participant

    Re: hotpoint BMW929

    not uncommon to go to these dead, board im afraid!

    March 31, 2007 at 11:06 pm #209537
    iadom
    Moderator

    Re: hotpoint BMW929

    hotpnt, does this always require a new board or can you use your lappy to reprogramme the eeprom for this fault. EMW are reporting an increase in this type of board failure on very late model Indesit/Hotpoint/Ariston machines.

    Jim.

    April 1, 2007 at 9:39 am #209538
    hotpnt
    Participant

    Re: hotpoint BMW929

    new board time!,

    April 1, 2007 at 10:14 pm #209539
    machineman
    Participant

    doyou know the part No for the mod.m

    April 2, 2007 at 9:10 am #209540
    iadom
    Moderator

    machineman wrote:doyou know the part No for the mod.m

    If you can confirm the ‘correct’ model number and possibly serial number. 😉


    Or you could EMW your BMW . 😆
    Jim.

    April 2, 2007 at 4:32 pm #209541
    machineman
    Participant

    sorry jim,its a bwm 129 serial No 701187815.m

    April 2, 2007 at 4:55 pm #209542
    iadom
    Moderator

    Re: hotpoint BMW929

    Personally I would get this off to EMW for a repair, this one should have 3 phase motor and it has a couple of different modules, one around £74.00 + vat list, the other over £93.00 + vat. And that is without eeprom. Looks like yours is the latter. 😥

    EMW are repairing these boards now. Around £40.00 + vat.

    Make sure you leave the machine unplugged for 10 minutes before touching it. 😯

    Jim.

    April 2, 2007 at 5:10 pm #209543
    machineman
    Participant

    thanks Jim

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.