Whirlpool ADP4403

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADP4403

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • April 2, 2007 at 2:29 pm #26323
    dja_1
    Participant

    Error code: 4 flashes, pause, 4 flashes etc. Anyone any ideas? Engineer says control board cost >£200 to repair!!! If correct can anyone recommend a new machine for around £250?

    April 2, 2007 at 6:21 pm #209719
    DentedPorsche
    Participant

    Re: Whirlpool ADP4403

    4 flashes is a draining failure. If it’s actually drained then most likely cause is the water indicator in the sump of the machine. Remove the filter and mesh filter and carefully clean out the black grid and try the machine again.

    DP

    April 5, 2007 at 11:07 am #209720
    dja_1
    Participant

    Re: Whirlpool ADP4403

    The black grid is a bit blocked with gunk, what is the best way to try and clean it?

    April 5, 2007 at 6:01 pm #209721
    Penguin45
    Participant

    Re: Whirlpool ADP4403

    Hot water and toothbrush. If it still won’t come clean, it’s a twist fit from underneath, then under the tap.

    Power off, of course.

    Regards,
    Penguin45.

    April 7, 2007 at 9:29 am #209722
    dja_1
    Participant

    Re: Whirlpool ADP4403

    Have cleaned and when turned back on the water used to clean has drained ok. It is not taking in water but the four flashes sequence is the same?

    April 7, 2007 at 12:20 pm #209723
    robwash
    Participant

    Re: Whirlpool ADP4403

    you need a new W.I. membrane switch, which is the grid switch in the sump. make sure the connections are dry as well.

    April 9, 2007 at 9:26 pm #209724
    dja_1
    Participant

    Re: Whirlpool ADP4403

    Finally got working; cleaned again with almost boiling water and toothbrush. As the original engineer totally misdiagnosed the problem am I in a position to demand the 47 pounds I paid out for the duff advice??

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.