Zanussi zwd1470

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi zwd1470

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 26, 2007 at 8:03 pm #26926
    msappliance
    Participant

    hello there,
    the above machine stops at 47 min after its main wash. spin and rinse light stays on?. this is a intermitant fault. thanks

    April 27, 2007 at 7:19 am #211943
    simtoms
    Participant

    Re: Zanussi zwd1470

    Ditto, only my machine is an AEG, 6100 Dig. enr 605 648 372.
    Cust complaining of taking too long to finish and I noticed it stuck on 47 for 10 -15 mins, before I aborted wash. Also intermittently won’t start; does initial pump out and then reverts back to start light flashing. Got that prob. on a Zanussi FLE1215W too….
    Board fault maybe?

    Simon.

    April 30, 2007 at 4:38 pm #211944
    simtoms
    Participant

    Re: Zanussi zwd1470

    oops, blundered on that one; the mod. of AEG is 72630w, PNC 91400209600, Now I’ve got the right info can anybody help?

    April 30, 2007 at 7:05 pm #211945
    comptonappliances
    Participant

    Re: Zanussi zwd1470

    HAD THIS FAULT ON AEG AND ZANUSSI ALWAYS ON 47 MINUTES .IS A HEATING PROBLEM U WILL NORMALLY FIND HEATER TESTS OK IN WHICH CASE THE MAIN BOARD IS FAULTY…. OR SO I FOUND.. STANGE THING IS I NEVER GOT AN ERROR CODE SHOWING RELATED TO THIS,HOPE THIS HELPS

    May 1, 2007 at 8:41 am #211946
    simtoms
    Participant

    Re: Zanussi zwd1470

    Thanks for that. Will try a new heater and see what happens. Any ideas on the not starting bit, where the door locks, pump runs and then start light flashes again as if prog. paused/not started?

    May 1, 2007 at 12:24 pm #211947
    comptonappliances
    Participant

    Re: Zanussi zwd1470

    not starting then lights flashing normally would be e52 motor tacho problem but without going into test and reading binary fault code hard to tell

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.