Blown timer neff s4456n

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Blown timer neff s4456n

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 2, 2007 at 6:42 pm #27083
    streetlighter
    Participant

    Hi all
    Just been to a neff dishwasher which wont program or start.
    The timer has blown conponents on the module. (2 tranys and the track)
    neff 483261 which is £90. Tested motor and part of the heater ( couldn’t get the integral d/w out ) also the dispensor. All seem fine.
    Is there a comon fault on these or could it just be the old dispensor problem ( which I have never seen before ) but it did test ok 1.2kohm ❓
    this is not the normal boshe module but a slightly smaller version.

    Ta for any help replacement integral d/w is dear so cons is prepared to pay a bit, but I can’t afford to destroy a £90 module.

    Paul

    May 3, 2007 at 8:00 am #212526
    Martin
    Participant

    Re: Blown timer neff s4456n

    That’s a tough one Paul to be honest. The dispenser solenoid is a known cause of modules blowing but by the same token the heater and its water point device can be suspect? Tracing the area of the blown components down through the wiring harness may point to the troublesome device? That’s not so easy but is your best hope. 😉

    May 3, 2007 at 11:46 am #212527
    streetlighter
    Participant

    Re: Blown timer neff s4456n

    Thanks martin
    I think it was the track to the dispensor and the aparently the dispensor has not worked for a while 😕
    Thanks again

    Paul

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.