Beko D2731FW Dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko D2731FW Dishwasher

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • June 4, 2007 at 6:56 pm #27869
    zimmy
    Participant

    Can anyone help, my Beko D2731FW slimline dishwasher is stuck at the beginning of it’s cycle, drain pump runs continuously but nothing else happens even if the dial is moved on! Is there a water level sensor or something, and if so where is it?

    June 4, 2007 at 8:44 pm #215942
    Penguin45
    Participant

    Re: Beko D2731FW Dishwasher

    The drain pump is running because the tray under the machine is full of water. Towels down, pull the plug and slowly and gently lean the machine back. When the water stops running out, the flood protection system will reset allow the machine to restart. Be advised that if it happens again, you have a leak to find.

    Regards,
    Penguin45.

    June 6, 2007 at 10:22 am #215943
    zimmy
    Participant

    Re: Beko D2731FW Dishwasher

    Thanks Penquin45 you were spot on. Now the problem has moved on, the water in the tray is coming from 2 pipes at the front of the machine, as if the machine is overfilling? Any more suggestions!

    June 6, 2007 at 1:41 pm #215944
    Washman
    Participant

    Re: Beko D2731FW Dishwasher

    Hi

    What detergent are you useing ie:- 3in1 or 4in1 tabs or loose powder.

    Mike

    June 6, 2007 at 5:24 pm #215945
    zimmy
    Participant

    Re: Beko D2731FW Dishwasher

    3in1 tabs usually

    June 6, 2007 at 8:27 pm #215946
    Penguin45
    Participant

    Re: Beko D2731FW Dishwasher

    Lots of froth…….. Have a read of this:
    http://www.ukwhitegoods.co.uk/modules.p … ge&pid=116

    Penguin45.

    June 7, 2007 at 8:13 am #215947
    zimmy
    Participant

    Re: Beko D2731FW Dishwasher

    Machine overflows without any detergent, it overflows like a tap being left on!

    June 7, 2007 at 6:37 pm #215948
    Penguin45
    Participant

    Re: Beko D2731FW Dishwasher

    In that case you have some sort of failure in the water level control system. This works by the displacement of air from a chamber into a diphragm switch. The chamber is possibly blocked or the switch itself may have failed.

    Power off before sticking fingers in……..

    Penguin45.

    June 10, 2007 at 7:41 pm #215949
    zimmy
    Participant

    Re: Beko D2731FW Dishwasher

    Took everything apart, cleaned it all, put it all back together and now it’s working fine. Until whatever it was comes back. Thanks for your help.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.