- This topic has 1 reply, 2 voices, and was last updated 18 years, 9 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi, the display was showing test with the machine filling & pumping.
I cancelled the test mode it then came up FO3 NTC fault,checked
the thermistor, loom, heater , removed the 3 phase board & cleaned edge
connectors & pinched the connector blocks.
still same problem, new board? anyone had this fault
Thanks Roy. 🙁
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.