HOTPOINT WMA BEARINGS

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › HOTPOINT WMA BEARINGS

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • July 20, 2007 at 5:21 pm #29156
    JOHN CLARKE
    Participant

    HOTPOINT WMA BEARINGS 30MM, Part No. for this bearing kit is C00254590, comes with both bearings and seals.

    July 20, 2007 at 6:01 pm #222110
    richardable
    Participant

    Re: HOTPOINT WMA BEARINGS

    john, is this a hidden question or a statement of fact in reply to a prevoius post?
    richard

    July 20, 2007 at 6:09 pm #222111
    JOHN CLARKE
    Participant

    Re: HOTPOINT WMA BEARINGS

    I had a problem getting these bearings so I thought I would broadcast the part No. for others to use, am I teaching my Granny to suck eggs.

    July 20, 2007 at 6:48 pm #222112
    richardable
    Participant

    Re: HOTPOINT WMA BEARINGS

    john, if you had a problem getting the bearings you will have a greater problem getting the old ones out. ususally i get a complete back half of the drum which comes complete with bearings.
    richard

    July 20, 2007 at 10:50 pm #222113
    iadom
    Moderator

    Re: HOTPOINT WMA BEARINGS

    richardable wrote:john, if you had a problem getting the bearings you will have a greater problem getting the old ones out. ususally i get a complete back half of the drum which comes complete with bearings.
    richard

    However, if the original has the 30mm bearings and shaft, the drum shaft will not fit the standard 1603409 rear half. Do you know of a part number for a 30mm rear drum half?

    Jim.

    July 21, 2007 at 5:55 pm #222114
    JOHN CLARKE
    Participant

    Re: HOTPOINT WMA BEARINGS

    HI, Thanks for the comments, have’nt tried for a 300mm rear half yet, do you think hotpoint have changed to 30mm on all models?
    I have managed to remove most of my 35mm bearings, takes a lot of hammering though, yes some of them are impossible.

    July 21, 2007 at 6:59 pm #222115
    iadom
    Moderator

    Re: HOTPOINT WMA BEARINGS

    JOHN CLARKE wrote:HI, Thanks for the comments, have’nt tried for a 300mm rear half yet,

    Now that would be one hell of a bearing, 😆

    Jim.

    July 23, 2007 at 3:21 pm #222116
    DAR01
    Participant

    Re: HOTPOINT WMA BEARINGS

    I think you will find that if the shaft needs replacing on a WMA machine with 30mm shaft the replacement parts are as follows.

    The new rear tub is Part No.1603409 which comes with bearings fitted for a 35mm shaft and you will also need to upgrade to a 35mm shaft Part No. 1604770.

    I think the 30mm shaft was upgraded due to premature failure of the seal originally used.

    Mike

    😮 😆 😆

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.