Hotpoint Ultima 1400 WM76 – Error code E30

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint Ultima 1400 WM76 – Error code E30

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • July 25, 2007 at 6:46 pm #29272
    admin
    Keymaster

    Hi

    i have tried using my Hotpoint and found it only filled up the prewash tray and then an E30 error came up. i have tried several times more to start the program but it will not fill with water at all now, going straight to the error code.

    i have various problems sometimes with this machine, sometimes the door gives an error, and sometimes it get stuck repeating a cycle over and over, but i can get round all those…..i could really do with knowing how to fix an E30 error though- i know an F30 error is a engine drive problem, is this also an E30? If so how can it be fixed?

    Also i have not had this machine from new…do you know how old it might be or where i can get a manual – i have tried the hotpoint service site to no avail.

    Thank you in anticipation of your help

    LJL 🙁

    July 25, 2007 at 9:06 pm #222545
    Penguin45
    Participant

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    E30 is no motor – probably the carbon brushes at that age (8-10 yearsish)

    Power off before extracting brushes.

    Regards
    Penguin45.

    July 25, 2007 at 9:16 pm #222546
    admin
    Keymaster

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    Thanks very much Penguin. That sounds like it is worth a try. Do you know what part we need and how much it would cost?

    Thanks

    July 25, 2007 at 9:21 pm #222547
    Penguin45
    Participant

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    http://shop.ukwhitegoods.co.uk/index.ph … 24_599_660

    One of the first two, depending upon which motor is fitted.

    Penguin45.

    July 25, 2007 at 9:26 pm #222548
    admin
    Keymaster

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    Brilliant! Do you know how i can tell?

    July 25, 2007 at 9:28 pm #222549
    Penguin45
    Participant

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    Er, the ones in the motor will look the same? The first ones are a snap fit into the sides of the motor, the FHP ones are screwed to the end frame.

    😀

    Penguin45.

    July 25, 2007 at 9:56 pm #222550
    admin
    Keymaster

    Re: Hotpoint Ultima 1400 WM76 – Error code E30

    Thanks very much for your help… i will let you know if it works!

    LJL 🙂

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.