Hotpoint Washing Machine Mod. WF740

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint Washing Machine Mod. WF740

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 31, 2007 at 8:11 pm #29424
    Ashby
    Participant

    Hi, This machine is coming up with fault code H20.
    I’ve changed the solenoid valve as that was faulty. The machine will start to fill and only take in a small amount of water. Then after a few moments the error code comes up. If i cancel the program and start it again a couple of times it will fill to the correct level and carry on until it comes to rinse.then it wont fill again. Has anyone elese had this problem?
    Thanks for your help.
    Ashby

    August 1, 2007 at 6:48 pm #223057
    Ashby
    Participant

    Re: Hotpoint Washing Machine Mod. WF740

    Hi Again,. Has anyone any idea what is going on with this machine please? Thanks.
    Ashby

    August 3, 2007 at 6:29 pm #223058
    iadom
    Moderator

    Re: Hotpoint Washing Machine Mod. WF740

    I have not come across this fault. not sure if any of the Hotpoint lads have. It could be a faulty main board or loose connections to the board although trying a pressure switch would be a cheaper alternative I rarely change pressure switches on these.

    Jim.

    August 5, 2007 at 8:37 pm #223059
    HotDog
    Participant

    Re: Hotpoint Washing Machine Mod. WF740

    Check pump/filter for blockage can cause back pressure if ok board faulty they nearly always are 😆

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.