Miele G694SC plus 3

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele G694SC plus 3

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 14, 2007 at 5:41 pm #29784
    Simon46
    Participant

    Got to go and look at this one tomorrow. Customer reports that a light is flashing check water/drain i think. He seems to think it isnt filling. Where do i start on this one please? Is it flood protection?It is my first.

    Regards
    Simon

    August 15, 2007 at 1:28 pm #224724
    Seamy
    Participant

    Re: Miele G694SC plus 3

    Check water in take 1st . Theres a float sw in base of this machine, to get access to machine take off top & sides. Check flowmeter (reed switch) you should wheel move around when its filling. Also check for level switch on curculation pump can give inlet fault too if it doesn’t register pressure.

    August 15, 2007 at 8:39 pm #224725
    Simon46
    Participant

    Re: Miele G694SC plus 3

    Turns out it was a connector at the front RHS got wet. brown and blue wire rumnning to back (inlet valve?)hardwired it, no sign of a leak though. 10 degree forward lean on dishwasher is the only thing i can contribute it to. levelled will see.

    S.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.