Siemens dishwasher SE24207gb/01 door leak

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemens dishwasher SE24207gb/01 door leak

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 16, 2007 at 6:52 pm #29841
    bubs
    Participant

    Hi,
    Went to a Siemens dishwasher SE24207gb/01 today, reported leak from door. This is the common bosch type with plastic base but has a mech timer unlike most. Sat and watched, no leak, then on a hot rinse the motor sped up
    and water came out the door, quite a bit. The water level looked fine, not overfill to activate pump. Door seals, wash arms all looked ok. Anything I maybe missing here?
    Thanks for any help
    Graeme

    August 16, 2007 at 7:17 pm #224888
    Penguin45
    Participant

    Re: Siemens dishwasher SE24207gb/01 door leak

    Change the bottom rotor – it’ll have a hairline crack in it somewhere.

    Chris.

    August 16, 2007 at 7:59 pm #224889
    gegsy
    Participant

    Re: Siemens dishwasher SE24207gb/01 door leak

    Hi
    Not seen any crack (only diplomat ones) but they can become detached on one side, leaving the spray arm angled and prone to cause leak.
    The other known culprit is the lower door seal.
    Remove the outer door panel and see if the rubber “well” of the lower door seal is still attached to stainless. If it isn’t you would be best ordering 298534 and replacing it.

    Greg

    August 17, 2007 at 5:32 am #224890
    bobokines
    Participant

    Re: Siemens dishwasher SE24207gb/01 door leak

    Have you taken the door outer panel off and checked it’s not leaking from the dispenser area and running down inside the door?

    If you run it with the door panel off you will see if it is leaking from the lower door seal

    Bob

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.