Smartdrive 051 dissassembly

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Smartdrive 051 dissassembly

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • August 20, 2007 at 10:37 am #29916
    Daynger
    Participant

    Hey folks, i have error 131 up that i diagnosed with the help of this site.
    Now my problem is getting to the spin motor.
    I have gotten most of the machine apart and have now just to remove the motor from the bottom of the drum. Do you unscrew the white cap from the bottom of the motor, or do you bash the shaft through from the top of the machine?

    Thanks
    Dayne

    August 20, 2007 at 8:21 pm #225179
    Penguin45
    Participant

    Re: Smartdrive 051 dissassembly

    Removing the rotor from the underside of the drum will give you sufficient access to the Rotor Position Sensor.

    Penguin45.

    August 22, 2007 at 6:07 am #225180
    Daynger
    Participant

    Re: Smartdrive 051 dissassembly

    Thanks penguin, but which part is the rotor and how do i get the thing apart.
    Is there any way to test the rps?
    Or is it a visual check only and replace kind of item?
    Do you happen to have a part number, as i have been arsed around by our local F&P counter jockies already with getting a pump.

    Thanks.

    August 22, 2007 at 6:56 am #225181
    bigsmokepiker
    Moderator

    Re: Smartdrive 051 dissassembly

    If You look under washer youll see a white Nut (Dead Centre)

    Remove Rotor With 16mm Socket (Nut comes away with rotor)
    Unscrew 4 Bolts That holds in Stator (Motor Windings)
    Remove Stator away from shaft turn over & Youll see RPS
    (Rotor postion sensor Little PCB)

    You can only Test RPS With Special Device
    Close visual check can be suffice
    Check tracks for Corrosion ETC
    While your There check Shaft Area for Signs of leaks
    RPS Part # 420296P ($55.00aud)

    August 23, 2007 at 7:32 am #225182
    Daynger
    Participant

    Re: Smartdrive 051 dissassembly

    Exactly what i was after thanks bigsmokepiker, i now have it apart and it looks like the board has a wee bit of corrosion on it, ill take it to f&p and get them to test it tomorrow.

    Thanks for your help guys.

    August 24, 2007 at 8:47 am #225183
    Daynger
    Participant

    Re: Smartdrive 051 dissassembly

    Got my parts today and its all systems go, thanks for all the help.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.