Bosch Dishwasher fault

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch Dishwasher fault

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 23, 2007 at 3:37 pm #30014
    RH5hz
    Participant

    Hi All,
    I’m new to the forum , and hoping I can get some help.
    I have a integrated Bosch dishwasher, Ser No:SH4313GB/13.

    It has a fault, which prevents it filling with water, at the start of its cycle. The dishwasher emmits a humming noise on start up, I cannot hear any water filling. This occurs on all programs.

    I have checked the following:
    -Water pressure ok to the Aquastop
    -Have disconnected(mechanically) the Aquastop at the valve, switched off diswasher and reconnected.
    -Have reset dishwasher by pressing 2 buttons on panel.

    The aquastop is sealed and I cant get into it to fault find, could it be this? or could be a fault with the dishwasher itself?
    Being an integrated unit. I want to make sure before I take half the kitchen apart. 😉

    Thanks in advance for any help with this.

    August 23, 2007 at 3:49 pm #225518
    Martin
    Participant

    Re: Bosch Dishwasher fault

    The baseplate likely as not is flooded and needs draining. Then careful investigations as to where the leak is coming from. 😉

    If you need a hand to check it out thec click on the link below for a local engineer. 🙂

    August 23, 2007 at 5:27 pm #225519
    RH5hz
    Participant

    Re: Bosch Dishwasher fault

    Martin,
    Thanks for the speedy reply, no engineers in my area (west Sussex). Can you give me an idea of how to drain the baseplate?

    ie:does the dishwasher need removing or can I do this insitu?

    Thanks 8)

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.