APM8513 i/a/w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › APM8513 i/a/w

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 5, 2007 at 8:27 am #30301
    Penguin45
    Participant

    Built in Merloni jobbie. Set timer, switch on,door locks, relays click on PCB and everything happens – except for motor action.

    We have a circuit through the motor and the loom. We have a circuit off the board through the motor. Heater is fine. Subbed in replacement board with no difference.

    What am I missing?

    Thanks,
    Chris.

    September 5, 2007 at 10:55 am #226700
    NWAR
    Moderator

    Re: APM8513 i/a/w

    We’ve been to a few the same and changing the PCB has fixed them – 546021400

    On the previous version you wouldn’t get anything after the door lock with a PCB fault but on these new ones we’ve seen them fill/drain/heat ok when the board goes.

    September 9, 2007 at 2:45 pm #226701
    Penguin45
    Participant

    Re: APM8513 i/a/w

    All right, my learned friends………

    I have:
    1/ Continuity tested every wire in the machine
    2/ Fitted one of EMWs’ finest recon modules further to NWARs comment
    3/ Fitted my spare timer (Hey – it’s Sunday, I’ve got time 🙁 )
    4/ Subbed in my spare motor
    5/ Infinite earth reading on the heater

    And it still won’t run the motor.

    I’m disinclined to believe in two duff modules (never had a duff one from EMW), so anything I’m missing here? Or shall I just send for the trebuchet?

    Chris.

    January 10, 2008 at 10:47 am #226702
    iadom
    Moderator

    Re: APM8513 i/a/w

    Is this machine made by Antonio Merloni or the Indesit mob?

    Jim.

    January 10, 2008 at 7:34 pm #226703
    Penguin45
    Participant

    Re: APM8513 i/a/w

    One of Toni’s……

    Finished up new timer and recon pcb.

    Chris.

    January 10, 2008 at 11:15 pm #226704
    iadom
    Moderator

    Re: APM8513 i/a/w

    I’m glad I passed on the one that phoned me today then. :rolls: 8)

    January 11, 2008 at 12:39 am #226705
    Penguin45
    Participant

    Re: APM8513 i/a/w

    Good call……. 😀

    Chris.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.