More fault codes from Indesit used on their WIDL range of washer dryers but can also be seen in Ariston and possibly Hotpoint washer dryers as well.
NOTE: False errors can be given by a faulty earth connection, make sure that the earth is good.
Faults that do not show a fault code
- Water turned off at the tap or inlet valve open circuit
- Some motor faults such as faulty carbons, plug out; the washing machine will lock but not start
- Open field coil will show fault F01
- Motor thermal cutout operates during the cycle; the washing machien machine will restart when the thermal cutout resets
- Wash element goes open circuit when full and operating, the washing machine will continue to wash
These fault codes are displayed by way of blinking or flashing light on the front of the washing machine similar to the patterns shown below with each representing a different area of failure.
Before you start any investigation of the fault or even remove the lid of your Indesit washing machine please read and fully understand this article in full and pay particular attention to the safety and information notices at the bottom of this page as they contain extremely important information!
Please remember to support our site by buying Indesit washing machine spares from our store and, if you decide that you need a washing machine engineer please support the local repairers that help make this site possible, you can search for an approved Indesit washing machine repairer using our free engineer search.
Indesit WIDL Washer Dryer Fault Codes
These fault codes are written for washing machine repairers and not for the general public by Indesit and they assume a certain level of competence on the part of the user in diagnostic routines. We have added some notes to try to assist you in determining the nature of the fault you have but, you will still need to investigate each failure on its own merits. For more help and advice on fault finding on a washing machine please refer to our basic fault finding guide from this link before you begin.
If you struggle or cannot find the appropriate fault code that you need for your Indesit machine please ask in the forums and the gusy there will do what they can to help and locate the meaning of the fault code you need
Please check that any Indesit washing machine spares recommended are suitable for use on your particular Indesit washer dryer model. If you are unsure about the suitability of any spare part please ask to ensure that you get the correct spares for your washer dryer. Please, don’t guess or assume as spares can be altered on a production run with the same model number having several different alternative components used.
Fault Code Lights Legend
This is our very simple legend to show the state of the lights, lamps or LED’s as they are unlit, flashing or lit continuously.
| Light or LED not lit | Light or LED flashing | Light or LED lit solid, no flash |
Indesit Fault Codes For WIDL Washer Dryers
F01 |
|
|
|
|
Short circuit motor triac on electronic module
|
F02 |
|
|
|
|
Motor fault detected – jammed rotor or drum or tacho detached
|
F03 |
|
|
|
|
NTC fault – temperature sensor detected as either open circuit or shorted
|
F04 |
|
|
|
|
Pressure switch jammed on empty
|
F05 |
|
|
|
|
Pressure switch jammed on full
|
F06 |
|
|
|
|
Not used
|
F07 |
|
|
|
|
Heater relay stuck
|
F08 |
|
|
|
|
Heater relay cannot be activated
|
F09 |
|
|
|
|
Incompatible EEPROM
|
F10 |
|
|
|
|
Pressure switch or level sensor not sensing correctly
|
F11 |
|
|
|
|
Drain pump cannot be activated
|
F12 |
|
|
|
|
Communication error between electronic control boards and wiring
|
F13 |
|
|
|
|
Dryer fan does not work or fan jammed
|
F14 |
|
|
|
|
Dryer element detected as open circuit or short
|
F15 |
|
|
|
|
Dryer element relay on board not working
|
F16 |
|
|
|
|
Not used
|
F17 |
|
|
|
|
Door lock error
|
F18 |
|
|
|
|
Communication error between electronic control boards and wiring
|
More Indesit Washing Machine Help, Advice And Guidance
Should you need more help and guidance please use the links from this article as most of them will help you to understand your Indesit washing machine a lot better and probably very much help you in diagnosing the fault you have. Of course there are many other articles on the site that will also help you do this.
In addition you can post in our help and advice forums after registering but please do pay heed to the information below before doing so and read the guides, they are there to help you.
You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other washing machines:
- We are not responsible for your safety, you are and by using this guide you accept that and accept that any damage that you may cause and work undertaken is entirely at your own risk.
- We will advise the common causes of the fault codes but we cannot guarantee that any parts or work recommended will resolve the issue. It is entirely your responsibility to diagnose your particular problem and resolve it.
- We are not responsible for you buying spares that do not resolve the problem, this is down to your own diagnosis not ours.
- No warranty is inferred, implied or given.
You also have to be aware that fault or error codes are not a “magic bullet”, they will not tell you what the precise problem is with your Indesit washing machine, they will only offer you an indication of where the problem lies and they are no substitute for diagnostic skills. You can find out more about what fault codes actually tell you in this article. So please be well aware that, even with this new found knowledge you will still have to actually be capable of investigating and diagnosing the problem and this means adhering to basic appliance safety for working on them.
Please do note that manufacturers can and do change fault codes without notice and we cannot guarantee that these error codes will apply to your particular model as all codes apply to a wide range of appliances and not normally any one specific model. To determine if these fault codes do apply to your particular Indesit washing machine model please post a request to confirm this in the forums.

Hi, I have a problem with my WITL-85 indesit washing machine.all 5 leds are blinking (include the one with the lock) together, and the machine won’t respond to any click.filter was cleaned up. electronics look fine.please help me with that one,thank you, Amit
Hi, hope my comment is not comming very late. Please check the brushes. Clean very well the contact area and in the gaps were carbon gather as brushes get worn. If the case change the brushes. Hope it hepls.
[quote name=”amit batsray”]Hi, I have a problem with my WITL-85 indesit washing machine.all 5 leds are blinking (include the one with the lock) together, and the machine won’t respond to any click.filter was cleaned up. electronics look fine.please help me with that one,thank you, Amit[/quote]I have the same problem. All leds are blinking very fast. Have you figured out yet by any chance what was the cause of that behaviour?
My indesit widl 106 rapidly lighting on 500/1000 and dont finish washing
Hi! I have flashing lights but the indicating ones seem to be vertical rather than horizontal. It’s a WIDL 126. It’s the bottom flashing, would that be the same as the right flashing. Thanks
Please help me with advice about Indesit washing machine IWB51251 that error code F15. (Car starts but soon stops and all LEDs blink in the top row and the start / pause)
Top 5 Led Are flashing (delay timer/ easy iron/ extra rinse/ 1200-1600/ lock) and the bottom one of the four vertical lights (9h). Anyone help me identify this?
Hi Lee,
Please use the forums and ask in there as the repair guys won\’t see you asking here.
My washer dryer stops when is comes to rinse. ALL buttons flash?
Pease help me with advice about Indesit washing machine IWB51251 that error code F15. (Car starts but soon stops and all LEDs blink in the top row and the start / pause)
A minha indesit de loiça não inicia nenhum programa, já verifiquei se a entrada de água estava interrompida e aparentemente está correto. O painel digital tem os leds a piscar, por favor preciso de ajuda. Obrigado
We have a Indesit Washer/Dryer IWDC6125 with all the lights flashing. We had a power failure through the night which affected our alarm system, we have reset this and all is good, it there a way to reset the washer/dryer or will it have blown something in the control panel?