servis m6002 going into spin

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › servis m6002 going into spin

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 7, 2007 at 1:58 pm #30369
    machineman
    Participant

    hello,

    I have a M6002 going into spin even when the machine is in the stop position.

    Ne ideas?

    It has to be board I’m thinking

    Cheers

    September 7, 2007 at 2:27 pm #226948
    timdowning
    Participant

    Re: servis m6002 going into spin

    Yes it is the board at fault. Insulation test the motor while you are at it. If motor ok just change the board.

    (Had the same fault last week on the same model)

    September 7, 2007 at 2:30 pm #226949
    Owain84
    Participant

    Re: servis m6002 going into spin

    brilliant Cheers!

    September 7, 2007 at 4:00 pm #226950
    Washman
    Participant

    Re: servis m6002 going into spin

    Hi

    Two common faults on these
    1– machine goes into spin when switched on and 2–machine totaly dead both mean new main boards.

    Mike

    September 7, 2007 at 6:48 pm #226951
    bazza500
    Participant

    Re: servis m6002 going into spin

    On some Servis machines when the machine is totally dead it is resistor R1 on the board. Replace it with a 8 to 47 ohm resistor of at least 2 watts and this will fix it.

    Could be the difference between writing it off or getting the repair.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.