BFI62 Fault, 2 Middle Lights flashing

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › BFI62 Fault, 2 Middle Lights flashing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 9, 2007 at 9:25 am #30401
    stehgt
    Participant

    Hi,

    Ive got a Hotpoint BFI62 about a week ago it stopped working it would try to run for about 10 seconds, then stop and beep once. It would then lock up and you had to reset it. I pulled it out yesterday (not really knowing what im looking for) and cleaned out the waste pipe as it was really full.. I put it back and it appeared to start working. But i can hear like a buzzing noise for the 1st minute or two like its trying to pump something but then it starts. After about 5-10 minutes it now stops and contantly beeps for about a minute. I open the door and it reports 2 middle lights flashing. Any ideas???

    Thanks alot

    September 9, 2007 at 9:32 am #227047
    Penguin45
    Participant

    Re: BFI62 Fault, 2 Middle Lights flashing

    Initial buzzing noise will be the drain pump running. The two flashing lights mean that the machine has not detected a fill with water in the time allowed. Water may be off, fill hose trapped or kinked, inlet valve may have failed or possibly a PCB fault.

    Power off before removing any panel.

    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.