FP GW703 Smartdrive

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › FP GW703 Smartdrive

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 19, 2007 at 7:10 am #30649
    disco0699
    Participant

    Hello,

    I was looking for some help with a F+P 703. It stopped working other day. I have installed a new Drain Pump. Now I have an error code 133 when reading left to right & adding binary code. Can anyone advise me what this means?

    Thanks Disco

    September 19, 2007 at 8:21 am #227953
    disco0699
    Participant

    Re: FP GW703 Smartdrive

    OK now have another problem.

    As soon as I turn on electricity at wall switch, the cold water solenoid opens & just continues to fill machine. It doesn’t matter if I turn it off at the power button on machine, whilst ever the electricticity is turned on the solenoid continues to operate. Any idea’s?

    September 19, 2007 at 12:02 pm #227954
    disco0699
    Participant

    Re: FP GW703 Smartdrive

    OK, now this piece of shite blew the fuse in the main board! and just keeps blowing fuses in an instant.

    I’m getting the feeling by the number of Fisher & Paykel enquiries for help on this website that these F+P washers have definitely got a “use by date” associated with them? Pretty pathetic really its not even 10 years old yet.

    September 19, 2007 at 7:20 pm #227955
    Penguin45
    Participant

    Re: FP GW703 Smartdrive

    133 is excess current detected at the motor. This can be a short circuit winding in the motor – this may well be borne out by it now blowing fuses.

    Inlet valve being on permanently can be a triac failure on the computer – possibly tertiary damage from the motor problem.

    Don’t be fooled by the large number of F+P posts – this forum seems to be the only one in the world offering advice!

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.